Deutsch
Suchen
Back to All Blog Posts

NitroData 4.0 Is Live: Automatic Checksum Correction and Restore to Original

NitroData 4.0 is live as of October 2026. This release brings two new modules: automatic checksum correction and restore to original. Both run inside the program, so you no longer need a separate tool.

Automatic Checksum Correction

NitroData 4.0 Checksum Calculation module
NitroData 4.0 Checksum Calculation module

When you change a file, the ECU's checksum values have to be updated too, or the device rejects the file. With clone devices in particular, this correction often meant using a separate tool. NitroData 4.0 moves the step into the program. It detects the checksum family of your file, calculates the correct values in seconds and writes them back.

  • No external tool, everything stays in the program
  • Automatic detection for EDC17, MED17, DCM and more families
  • Unrecognized formats are not processed, for safety

Restore to Original

NitroData 4.0 Restore to Original module
NitroData 4.0 Restore to Original module

When you need to take a file you have worked on back to its factory original state, you can do it in one step inside the program. You go from the modified file to the original calibration using verified references. There is no need to look for a reference file or start over.

  • One step, inside the program
  • A safe result from verified references
  • If the match is uncertain, no file is delivered, so there is no wrong result

A Refreshed Interface

The interface was refreshed for both modules. It is simpler and easier to use.

NitroData 4.0 brings file preparation and verification together in one program. You can try the new modules from your account.

Kommentare
Write a Comment Close Comment Form